How Do I Set Up an EMV Reader for RecDesk Payments?

  Overview

In this article, you will learn how to set up an EMV reader for use with RecDesk Payments.

  Before You Start

You must be a RecDesk Payments client and have previously purchased/leased your readers from POS Portal. 

How to Set Up Your RecDesk Payments EMV Reader

WIFI EMV Reader Setup for INGENICO LINK 2500

1. Turn on the device (press Green button);
2. Press 2634, then press F to access the menu;
3. Find the option to connect via Wifi (press F2 to scroll up and F3 to scroll down): 
   1. Go down to Control Panel
   2. Terminal Settings; 
   3. Comm Means; 
   4. WIFI;
   5. Scan Networks;
   6. Select your network and enter the password;
4. Once connected, reboot the device;
   1. Press # and the yellow button to reboot.
   2. You should see an activation code on the screen. When you meet with RecDesk support, they will need that number to configure the device.

Ethernet EMV Reader Setup for INGENICO LANE 3000, INGENICO LANE 3600

1. Plug in the Ethernet cord;
2. Turn on the device (press Green button);
3. Press 2634 and then press F to access the menu;
4. Find the option to connect via Ethernet (press F2 to scroll up and F3 to scroll down):
   1. Go down to Control Panel;
   2. Terminal Settings; 
   3. Comm Means; 
   4. Ethernet;
   5. If you see an IP Address, this means you are connected to the internet via Ethernet;
5. Once connected, reboot the device;
   1. Press # and the yellow button to reboot.
   2. You should see an activation code on the screen. When you meet with RecDesk support, they will need that number to configure the device.

  Tips:

• When connecting to wifi, be sure your PC is not connected to to the network using an Ethernet cable.
• If there is a connection issue (flashing green light), reboot your device by pressing # and the yellow button to reset the connection.